Products
PD-free Power Frequency Partial Discharge Tester For 35KV Transformer
video
PD-free Power Frequency Partial Discharge Tester For 35KV Transformer

PD-free Power Frequency Partial Discharge Tester For 35KV Transformer

1. Model HYJF-15KVA/75KV PD test system.
2. Test object: 35kV voltage level such as transformers, power transformers, high-voltage circuit breakers, cable.
Product Introduction

 

HYJF-15KVA/75KV PD-free Power frequency partial discharge tester  This test system is mainly used for some power products below 35kV voltage level such as transformers, power transformers, high-voltage circuit breakers, cable accessories, and other test products for power frequency voltage resistance, partial discharge test, and scientific research test.

Work condition

Territory height: ≤1000m

Ambient temperature: -20℃~+40℃

Relative air humidity: ≤90% (25℃)

The waveform of the power supply voltage is an actual sine wave, and the waveform distortion rate is <3%

Set up a reliable grounding point with grounding resistance <0.5Ω

Installation location: indoors

 

Product Parameter

 

HYJF-15KVA/75KV PD-free Power frequency partial discharge tester  composed device

YDJ-15kVA/75kV Non-PD test transformer 1 set

TCJHT-15KVA-15/0.38/0~0.42 voltage regulator 1 set

FRC-400pF/75kv coupling capacitor 1set

DZ-0.2/5 Protection resistor 1 set

TCJH-15KVA Controller(manual) 1 set

HYLBQ-15/0.4 power filter 1 set

Cable and accessory 1 set

Accessory

 

Model: YDJ-15/75 PD-free test transformer 

Structural type: Insulated cylinder type

Number of phases: single phase

Frequency: 50Hz

Rated capacity: 15kVA

Rated input voltage: 0.4kV

Rated input current: 37.5A

Rated output voltage: 75kV

Rated output current: 0.2A

Output waveform distortion rate: ≤3%

Power frequency withstand voltage level: 82.5kV/1min

Running time: rated voltage and rated current can run continuously for 5 minutes; 2/3 rated voltage and 2/3 rated current allow continuous operation

Local discharge: ≤3pc at rated voltage, ≤2pc at 80% rated voltage

Cooling method: oil-immersed self cooling

Structure: The insulating shell is wound with epoxy glass wire

Temperature rise: < 45K

Impedance voltage: < 10%

No-load current: < 5%

 

Model:TCJHT–15/0.38/0~0.42 voltage regulator

Number of phases: single phase

Frequency: 50Hz

Rated capacity: 15kVA

Rated input voltage: 0.38kV

Rated input current: 39.5A

Rated output voltage: 0~0.42kV

Rated output current: 35.7A

Waveform distortion rate: <3%

Starting voltage: ≤1%

Running time: 1 minute at 1.1 times rated voltage, 30 minutes of continuous operation at rated voltage and rated current

 

Model:FRC-400pF/75kv coupling capacitor

Rated frequency: 50Hz

Nominal capacitance: 400pF

Rated voltage: 75kV

Partial discharge level: 100% rated voltage ≤ 3pC, 80% rated voltage ≤ 2pC

Structural type: Insulated shell oil-paper capacitor structure. It consists of a top cover, a capacitor body, a mobile base, a low-voltage arm, etc.

The voltage divider also serves as a coupling capacitor for partial discharge measurements.

 

Model: DZ-0.2/5 Protection resistor

Rated voltage: 75kV

Rated current: 0.2A

Nominal resistance: 5kΩ

Local discharge level: 100% rated voltage ≤3pC, 80% rated voltage ≤2pC

Structure type: The enameled nickel-chromium wire is wound on the epoxy cylinder, and the connecting tubes are configured at both ends to connect with the transformer divider

There is a shielding ring at the end; when the subject is discharged, the protection resistance will not cause insulation damage.

 

Our certificates

Certificates -2

Customers visiting

 

 

customer visit

 

About us

 

Wuhan Huayi Electric Power Technology Co.,Ltd

 

HUAYI is a professional manufacturer in China that researches and manufactures electric testing equipment. Established in 2005, the company is one of the earliest manufacturers of high-voltage testers in China. HUAYI insists on developing and marketing independently and makes efforts to improve the products' quality, reduce cost, and improve efficiency.
HUAYI is committed to preventative, maintenance, troubleshooting, and commissioning. With ISO certificated, professional engineering support, and Satisfactory customer service, our brand has been recognized and supported by wide users.

 
01
 

large enterprise scale

Efficient and precise processing and testing equipment. We have our factory, engineers, and service team.

 
02
 

Standardized Production

Passed ISO9001 certification and obtained relevant patent certificates.

 
03
 

High-Quality Customized Services

No intermediate links, providing one-stop service from design, processing, mold trial to mass production.

company

 

How To Cooperate With Us?

Please get in touch with us if you have any questions about products, prices, technology solutions, or services. We always be with you.

Our address

Gaoxin 4th Road, No.40, Wuhan city, China

Phone Number

(86)-18062012971/+8618064115448 WhatsApp

E-mail

sales@sinohipot.com/ tina@sinohipot.com

HUAYI
modular-1
One-stop high voltage test equipment Factory in China

 Send your inquiry about test equipment to us and experience the professional solutions it can have on your business or brand. With our technology solutions and products, you can elevate your products, captivate your customers, and unlock new opportunities for growth and success in the electric industy.

Hot Tags: pd-free power frequency partial discharge tester for 35kv transformer, China pd-free power frequency partial discharge tester for 35kv transformer manufacturers, suppliers, factory, hipot test for 33kv cable, Cable partial discharge testing equipment, Quantitative PD test, partial discharge detector with gps, handheld PD detector, Partial Discharge Detector

Send Inquiry